Removing and installing piston with connecting rod Installing piston with connecting rod Note: If the pistons must be changed, ascertain by measuring the pistons or reading the measurement on the top of the piston whether undersized pistons were installed. If this is the case, undersized pistons must be used. Fig. 5 Check bearing shells for wear and damage. Measure the spread as for main bearing shells. Install new bearing shells if necessary. When repairing connecting rod bearing journals, use bearing shells of the corresponding repair stage. 5 Fig. 6 Insert bearing shells into the connecting rods or connecting rod bearing caps. Caution: The rod shell has a red or yellow mark on the side.
6 The top coat must not be damaged. Apply a thin coat of oil to the connecting rod bear- ing shells. Fig. 7 Apply a thin coat of oil to the cylinder liners and pistons. Arrange piston ring gaps with an offset of approx. 120 _ . Apply piston ring tightener and tighten piston rings. 7 Fig. 8 Insert the pistons so that the recess on the piston skirt points towards the oil spray nozzle. Guide connecting rod and insert piston until con- necting rod big end contacts the connecting rod bearing journal. Caution: Do not damage oil spray nozzles. 8 107