MAN — Removing and installing piston with connecting rod

Removing and installing piston with connecting rod Fig. 9 The arrow on the top of the piston must always point towards the engine centre, i.e. towards the injection pump. 9 Fig. 10 Put connecting rod bearing caps in place. Caution: The numbers on the connecting rod bea- ring cap and connecting rod big end must be on one side. 10 Fig. 11 Screw in connecting rod bearing bolts and tighten them in stages to specified value. Tighten finally by angle. (For tightening torques and reusability of bolts, see “Service Data”.) 11 Fig. 12 Slowly turn engine over. Connecting rods and oil spray nozzles (arrow) must not collide or grind against each other.

Refit in reverse sequence to the removal pro- cedure all parts previously removed. 12 108