MAN — Replacing cylinder liners

Replacing cylinder liners Removing cylinder liners Note: Observe oversizes for cylinder liner outer diameters and collar heights (see “Service Data ”). D Remove cylinder head, see page 79 D Remove pistons, see page 106 Fig. 1 1 Mark cylinder liner position relative to engine so that it can be reinstalled in the same position if re- used. Insert cylinder liner extractor device (special tool) into cylinder liner, taking care not to damage the oil spray nozzle. Put support on extractor spindle and tighten nut. Fig. 2 Hold extractor spindle in place and extract cylinder liner by turning nut. 2 Take off extractor device and take out cylinder liner. Fig. 3 Deposit cylinder liner upright.

Take off O-rings. Number cylinder liners in order of installation. 3 Installing cylinder liners Fig. 4 Checking cylinder liner protrusion Clean basic bore and cylinder liner. Insert cylinder liner without O-rings into crankcase, observing the marking (ensure that it is identical with the position prior to removal). Measure cylinder liner protrusion at at least four different points, using gauge holder and gauge. 4 113