Replacing cylinder liners Fig. 5 Note: After fitting the cylinder liners ensure that the O-rings are in the correct position by checking the liner protrusion with special tool. Use special tool, see page 178, as follows: Position press-on measuring plate with turned collar facing the liner using 2 fitting sleeves to centre plate. Tighten 4 bolts (improvised: collar bolt 51.90020-0270, length shortened to 90 mm) on the press-on measuring plate in stages and crosswise to 40 Nm. Set dial gauge combination above press-on plate to 0 under preload relative to the crankcase. Measure cylinder liner protrusion at least at four points.
A B 1 2 5 The cylinder liner protrusion is the difference be- tween the collar height and the collar recess in the crankcase. 1 Crankcase 2 Cylinder liner B−A = cylinder liner protrusion 6 Fig. 6 Install shim if the protrusion is below the minimum protrusion even at only one point. The shim is placed under the cylinder liner collar. However, it may be used only if after installation the upper tolerance limit is not exceeded. Fig. 7 Oil new O-rings for the lower seal (144x4) and in- sert them in crankcase. 7 Fig. 8 Insert new O-rings for the upper seal (138x2) into the grooves on the cylinder liner. Do not overstretch the O-rings. 8 114