V-belts Checking condition Fig. 1 D Check V-belts for cracks, oil, overheating and wear D Change demaged V-belts 1 Checking tension Fig. 2 1 Use V-belt tension tester to check V-belt tension. D Lower indicator arm А into the scale 2 Fig. 3 D Apply tester to belt at a point midway between two pulleys so that edge of contact surface Б is flush with the V-belt D Slowly depress pad В until the spring can be heard to disengage. This will cause the indica- tor to move upwards 2 If pressure is maintained after the spring has dis- engaged a false reading will be obtained! 3 3 Reading of tension Fig.
4 D Read of the tensioning force of the belt at the point where the top surface of the indicator arm intersects with the scale D Before taking readings make ensure that the indicator arm remains in its position If the value measured deviates from the setting value specified, the V-belt tension must be cor- rected. 4 119 Tensioning forces according to the kg graduation on the tester Drive belt New installation When width Installation After 10 min. run- ning time servicing after long running time 2/3VX 90−100 70−80 60 4/3VX 180−200 140−160 120