Electronic speed control 1 LED display for electronic overspeed control 2 Output contacts “Overspeed” LED display for overspeed 3 Overspeed reset button: initial position of the relay contacts after overspeed signal has been sent. Resetting can also be effected by briefly interrupting the battery power supply 4 Overspeed test button, lowers the switching point by approx. 12 % 5 25-step potentiometer: setting of overspeed. Let engine idle, press test button and simultaneously turn it left until engine stops and the display comes on 6 25-step potentiometer: setting of rated speed 7 Setting of stability 8 Setting of sensitivity 9 Additional assistance for stability improvement.
In the event of very slow pendulum motion, set 10 - 20 mF condensator from E3 to E2 10 This makes it possible to set the lower idling speed limit if “L” and “M” are connected 11 Setting the P degree if “L” and “K” are connected 12 Stabilised voltage 10 V for triggering additional modules 13 Input for signals from synchroniser, load divider, smoke limiter etc. 14 Connect “G” and “H” only if a high P degree (10 %) is required 15 Operation at low idling speed if L and M are connected 16 P degree if “K” and “L” are connected 17 Speed precision setting (only required for remote control) 18 Battery 19 Pulse generator 20 Final control element Caution:
Except in emergency cases, the engine must never be switched off by interrupting the cables for the final controlling elements, but only by interrupting the battery supply. 124