Troubleshooting with GAC governor Fig. 1 The control unit is equipped with a terminal strip for the connections of the output and input signals. 1 Checking procedure: Engine does not start. BATTERY + Fig. 2 E F Check battery voltage on control unit during start- ing procedure. Min. value: 17 V direct voltage Otherwise exchange battery or reduce voltage drop in the supply line. V _ 2 Figs. 3 and 4 Check speed pickup signal on control unit during starting procedure. PICK-UP C D Min. value: 0.8 V alternating current Otherwise check distance “d” of speed pickup, if necessary correcting it, see page 127.
If distance “d” is correct, but the voltage still too low, disconnect cable from terminals “C” and “D” on the control unit and measure the resistance be- tween both cables. V ~ Correct value: 150 - 200 W 3 If value deviates, exchange speed pickup. d 4 125