165 Torque guide values Retightening cylinder head bolts on new engines ( Engine cold or warm) Zweiter Nachzug der Zylinder- The cylinder heads are fitted with cylinder-head kopfschrauben erledigt bolts for rotation angle tightening. On new engi- nes, the cylinder-head bolts are retightened at the Second retightening of cylinder- factory after running in and marked by the sticker head-bolts completed “First retightening of cylinder-head bolts ...” on a cylinder head cover. After the first 400 hours of operation, following a Spare part no. 51.97801-0211 repair, tighten the cylinder-head bolts 1 to 4 in the order specified in the tightening schedule “1” by 90° (1/4 turn).
Intake side / injection nozzle The two outer bolts (intake and exhaust side) must not be retightened. 1 4 Note: After the first 400 hours of operation re- tighten cylinder head bolts 1 to 4 in the order shown in Tightening diagram 1” by a further 90° (1/4 turn). 3 2 MAN Exhaust side Tightening schedule “1” Remove the sticker “First retightening of the cylinder-head bolts ...” and attach the sticker “Second retightening of the cylinder-head Zweiter Nachzug der Zylinder- bolts ...” to verify the second retightening. kopfschrauben erledigt Second retightening of cylinder- head-bolts completed Spare part no. 51.97801-0212 MAN