Flame-starter sheathed-element glow plug, removing and installing Removing sheathed-element glow plug Fig. 1 Disconnect the electric connections from the sheathed-element glow plug. Remove fuel line carefully. Loosen counter nut on sheathed-element glow plug and remove glow plug. 1 Installing sheathed-element glow plug Fig. 2 Turn counter nut on sheathed-element glow plug upwards until it stops and apply “Curil T” sealant to threaded portion. Screw in sheathed-element glow plug with new sealing ring until it stops at the counter nut and align it with fuel line. Connect up fuel line and electric connection. Tighten counter nut.
2 Checking solenoid valve for leaks Remove fuel line from flame glow plug. When the engine is running and hot, no fuel must emerge. Removing solenoid valve Fig. 3 D Remove fuel lines D Pull electric connection off valve D Remove the two hex bolts and take off valve 3 The valve cannot be repaired. Exchange the defective valves. Fitting solenoid valve D Screw valve to holder D Push on electric connection D Fit the fuel lines with new sealing rings 39