MAN — Removing and installing thermostat insert

Removing and installing thermostat insert Fig. 1 D Drain coolant, see page 40 Remove the three mounting bolts from the coolant neck and take off coolant neck. Fig. 2 Take out short-circuit inserts / thermostats. Check the function of the thermostat insert as follows: 1 D Hang thermostat in a pot filled with water D Heat water D Use suitable thermometer to ascertain the opening start and compare it with the set-point value given in “Service Data” D Measure opening stroke if necessary Exchange defective thermostats. Insert thermostat inserts ball valve facing upwards (“TOP”) with new O-ring seal and new seal. Caution: Never let engine run without thermostats or short-circuit inserts. 2 42