Repairing engine water pump Fig. 9 Turn water pump housing over. Press in new mechanical seal with press-fitting sleeve (special tool) until it stops. Observe installation note for seal on page 51. Note: The seal can be exchanged even without removing the water pump shaft. 9 Fig. 10 Slowly press impeller on to bearing shaft to ensure correct gap. 10 Fig. 11 For this purpose an inspection hole closed up with a screw plug (M16 x 1.5) is provided on the bottom of the water pump housing. 1 2 1 Impeller 2 Water pump housing X = D 2840 LE 2.. 0,5−0,9 mm D 2848 / 42 LE 2.. 0,7−0,8 mm 11 X Fig. 12 Fit new pump cover and press it into housing, using a suitable pressing tool. 12 47