Repairing engine water pump Water pump for two thermostats Fig. 14 1 1 Pump housing 2 Impeller 3 Axial face seal 4 Water pump bearing 5 V-belt pulley / hub 6 Circlip 2 3 4 5 Removing water pump, see page 43. 6 14 Disassembling water pump Fig. 15 Clamp water pump in vice (using soft jaws). Pull off V-belt pulley with three-arm puller. Unclip the circlip from the water-pump housing. 15 Fig. 16 Press impeller off the shaft, using a suitable man- drel. For this purpose align water pump housing horizontally on a stable support. The picture shows an assembly device for this. If such a device is not available, use a support ring (special tool).
Use a suitable mandrel to press the water pump shaft together with bearing out of the housing. Shaft and bearing are encapsulated and ex- changed together only. 16 Assembling water pump Fig. 17 Press in water pump bearing. Use a hollow mandrel to apply pressure to the bearing outer ring but not to the bearing shaft. Refit circlip. 17 49