Repairing engine water pump Fig. 18 Turn water pump housing over. Press in new mechanical seal with press-fitting sleeve (special tool) until it stops. Observe installation note for seal on page 51. Note: The seal can be exchanged even without removing the water pump shaft. Fig. 19 18 Slowly press impeller on to bearing shaft to ensure correct gap. The correct gap dimension (see “Service Data”) is achieved if the outer face of the impeller is flush with the front face of the bearing shaft. Check the gap dimension with the feeler gauge. The impeller must be easy to turn and must not contact the water-pump housing. Turn pump housing over and press V-belt pulley flush on to bearing shaft.
For this purpose place bearing shaft together with the flush-fitting impeller on a stable support. 19 50