Removing and installing valve guides D Removing and installing cylinder head, see page 79 D Removing and installing valves, see page 86 Fig. 1 Press valve guide out of the combustion chamber side using pressing mandrel (special tool). Oil new valve guide and drive / press it into the cylinder head using pressing mandrel and spacer sleeve (special tool). 1 Fig. 2 The valve guides vary only in length. 1 Inlet = long guide 2 Exhaust = short guide 3 Press-in depth (see “Service Data”) 3 1 2 The correct press-in depth is obtained by using the spacer sleeve. Afterwards ream valve guide to specified dimension. Note:
When the valve guides have been changed, the valve seats too must be re- worked (see technical data and manufac- turers’ instructions for valve seat lathes found in individual workshops). 2 89