3) TWO SPEED CHANGE MECHANISM (1) When running at 1st speed (low speed) M1 M2 Spring Spool Pi1 Pi2 Face b Face c Piston S/A Valve plate Steel ball Low pressure Fp + Fs2 Port C(low pressure) Spring Swash plate Face a Swash plate control piston Spring Port B(High pressure) 8007A2TM10 Swash plate has three faces, from "a" to "c", as shown in the figure, and installed in the flange holder with two steel balls in the condition where it can be tilted.
When the control valve is set to the 1st speed position, spool is placed in the position shown in upper figure by the force of spring, and the passage of swash plate control piston passes across the Pi1 and Pi2 port positions and led to the tank port. Therefore, the force pushing up the swash plate does not act on swash plate control piston. Fp=(Ap Ч P)=0 Fp : Swash plate control piston thrust Ap : Swash plate control piston pressure receiving area P : Pressure 2-64 F + Fs1 L1 Lo