Kaiyi — 4. TRAVEL DEVICE

(2) When running at 2nd speed (high speed) Spring Spool Pi1 Pi2 Valve plate Low pressure Fp + Fs2 Spring Swash plate Face a Swash plate control piston Spring Port C(low pressure) Port B(High pressure) 8007A2TM11 When control valve is set to the 2nd speed position, the pressure oil delivered by the pump is led to spool, and spool is switched to the position shown in the figure. And the pressurized oil flows into each ports Pi1 and Pi2 through ports M1 and M2 and the motor driving pressure (P1: high pressure and P2: low pressure) is led to each swash plate control piston. Therefore the force pushing up the swash plate acts on swash plate control piston.

Fp1=Ap Ч P1 Fp2=Ap Ч P2 When steel ball is placed on the tilting center, the balance of moment acting on swash plate is in the condition of ( F+Fs1) Ч L1 Ч Lo depending on the total F of driving force of piston S/A. The face "b" of swash plate stabilizes and the swash plate angle becomes " β " angle, consequently the motor speed is the 2nd speed (high speed). While the engine is stopped, spool is returned to the 1st speed position by the force of spring since pressurized oil does not flow.

When steel ball is placed on the tilting center, the balance of moment acting on swash plate is in the condition of Fs Ч L1>Fp Ч Lo, the face "a" of swash plate stabilizes and the swash plate angle becomes " α " angle, consequently the motor speed at starting is always the 1st speed. 2-65 M1 + Fs1