Kaiyi — 4. TRAVEL DEVICE

4) AUTO TWO SPEED CHANGE MECHANISM Auto two-speed control mechanism consists of two spools and spring. This valve automatically changes motor displacement in portion to motor pressure. This valve works while the pilot port "Ps" is pressurized. (1) Motor pressure is low. The motor displacement is small (high speed displacement) as shown figure. When the two-speed spool is on the right position. Motor pressure Pm1 and Pm2 are connected to each side of chamber of two speed piston. So swash plate is moved to high-speed position by two-speed piston and motor displacement is kept on high-speed position. Pilot pressure is applied on the area "Ap" when Ps port is pressurized.

Then the pressure of Ps pushes the spool to the right direction on figure. At the same time, Motor inlet pressure is applied on the area "Am". So, the spool is also applied to the left direction by Am pressure. According to above, if the motor pressure is lower and keeps the following condition, the spool stays on the right position. Ps Ч Ap Am Ч Pin+Kx Kx : Spring force AP : Swash plate control piston pressure receiving area Ps : Pilot pressure Pilot pressure acting area(Ap) Pilot pressure oil Oil passage A Pilot pressure oil chamber Motor load pressure chamber Drain Dr1 Drain Dr2 Oil passage B Pm2 : Motor pressure Spool movement direction (2 speed at nornal condition) 2 speed spool Pm1 :

Motor pressure Pin : Motor load pressure 8007A2TM12 2-66