Kaiyi — 4. TRAVEL DEVICE

7) REDUCTION GEAR The reduction gear is composed of a three-stage planetary gear mechanism shown in the following figure. Since the sun gear is designed to have a floating mechanism, errors of the gears and carrier pin hole pitches will not affect the gears' lives heavily. R 3 R 2 R 1 C 3 C 2 C 1 P 3 P 2 P 1 S 3 S 2 S 1 R290TM08(1) The input rotation of the hydraulic motor is transmitted to No. 1 sun gear (S1) and this drives No. 1 planetary gears (P1). This No. 1 planetary gears (P1) drive No.1 ring gear (R1) with the same force as the meshing tangential force with No. 1 sun gear (S1), and also No. 1 carrier (C1) with the same force as the meshing reaction force. In other words, No.

1 planetary gears (P1) revolve rotating. This rotation of No. 1 carrier (C1) becomes the output of the 1st stage, and is transmitted directly to No. 2 sun gear (S2). (No. 1 carrier is spline-coupled with No. 2 sun gear.) Similarly the revolution of No. 2 planetary gear (P2) are transmitted via No.2 carrier (C2) to No. 3 sun gear (S3). Since No. 3 carrier (C3) supporting No. 3 planetary gears (P3) are fixed, No. 3 planetary gears (P3) do not revolve, but rotates to drive No. 3 ring gears (R3). Therefore, the rotating case is driven by the overall driving torque of numbers. 1,2 and 3 ring gears. This reduction ratio is expressed as shown below:

i = - 1 (Z S1 + Z r1 ) (Z S2 + Z r2 ) (Z S3 + Z r3 ) Z S1 · Z S2 · Z S3 where Z : Number of teeth of each gear The direction of rotation is reverse to that of the input shaft. 2-71