Kaiyi — 3. AUTOMATIC DECELERATION SYSTEM

GROUP 3 AUTOMATIC DECELERATION SYSTEM Work pressure Travel pressure Main control valve PS PS Engine ECM Main pump Pilot pump Cluster CAN #1 MCU Pressure signal Haptic controller Auto idle pilot lamp OFF CLUSTER AIRCON Auto idle switch signal CAN #1 & #2 CAN #2 900L5MS16 1. WHEN AUTO IDLE PILOT LAMP ON When all of the work equipment control levers including swing and travel levers are at neutral for 4 seconds, MCU sends throttle command to ECM to reduce the engine speed to 1000 rpm . If the control levers are at neutral for 1 minute, MCU reduces the engine speed to 850 rpm .

As the result of reducing the engine speed, fuel consumption and noise are effectively cut down during non-operation of the control levers. When the Auto idle pilot lamp is turned off by pressing the switch or any control lever is operated, the reduced engine speed rises upto the speed before deceleration in a second. Engine rpm Multimodal dial set rpm Auto idle rpm Low idle rpm Lever operation Lever neutral Time 900L5MS03 2. WHEN AUTO idle pilot LAMP OFF The engine speed can be set as desired using the multimodal dial, and even if the control levers are neutral, the engine speed is not reduced. Auto idle function can be activated when multimodal dial position is over 4. 5-6 4 sec 60 sec