5. WHEN AIR CLEANER WARNING LAMP LIGHTS UP (engine is started) · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted. · After checking, insert the disconnected connectors again immediately unless otherwise specified. Check resistance MCU AIR CLEANER SWITCH 1 Pa 2 29 AIR CLEANER CLOGGING SW CN-51 CD-10 900L6ES06 6-28 YES Does display go off when disconnect YES CD-10? Starting switch : ON Engine : Running Check resistance between CN-51 NO (29) and chassis Starting switch :
OFF Disconnect CN-51 NO Cause Remedy Clogged air filter or defective switch Short circuit in wiring harness between CD-10- CN-51 (29) Defective MCU Check filter or replace switch Repair or replace (After clean) Replace YES MAX 1Ω NO MIN 1M Ω