Check Table CN-126 CN-51 connector 900L6ES02 6-27 4. WHEN COOLANT OVERHEAT WARNING LAMP LIGHTS UP (engine is started) ·Before disconnecting the connector, always turn the starting switch OFF. ·Before carrying out below procedure, check all the related connectors are properly inserted. ·After checking, insert the disconnected connectors again immediately unless otherwise specified. YES Check resistance YES between engine harness connectors Spec : 180Ω~160 kΩ NO Check resistance between temp sensor (A)-(B) Starting switch : OFF Spec :
180Ω~160 kΩ See table NO Cause Remedy Check use HRDT Disconnection in wiring harness or poor contact between temp sensor-engine harness connector Defective coolant temp sensor Check or replace Repair or replace (after clean) Replace Temperature (˚C ) 0 25 50 80 95 Resistance (kΩ) 30~37 9.3~10.7 3.2~3.8 1.0~1.3 0.7~0.8 EMS INTERFACE 1 BATT. ECM SERVICE TOOL 2 GROUND CAN Lo F 6 31 3 IGN ECM CAN Hi E 5 21 4 BATT. ECM ENGINE COOLANT TEMPERATURE SE 5 GROUND RS232 TX C 3 24 6 CAN SIGNAL HI A RS232 RX B 2 34 7 CAN SIGNAL LOW B C 8 ENG.RUNNING +24V P DUMP A 1 16 Engine harness CAN Lo F 6 5 3 2 1 31 21 24 34 16 CAN Hi E RS232 TX C RS232 RX B P DUMP A A B C