3. BATTERY CHARGING WARNING LAMP LIGHTS UP (Starting switch : ON) · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted. · After checking, insert the disconnected connectors again immediately unless otherwise specified. Check voltage CN-74 B+ G ~ 3 ENGINE ECM I GND U ALTERNATOR 900L6ES09 6-26 YES Check voltage YES between engine ECM and chassis Voltage : 20~32V Check voltage NO between alternator terminal "I" and chassis Engine : Running Voltage :
20~32V NO Cause Remedy Defective ECM Disconnection in wiring harness or poor contact between engine ECM alternator terminal "I" Defective alternator Replace Repair or replace (after clean) Replace YES 20~32V NO 0V