COMMUNICATION ERROR FLASHES ON THE CLUSTER (HCESPN 840, FMI 2) 2. · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted. · After checking, insert the disconnected connectors again immediately unless otherwise specified. Check voltage CLUSTER GND MCU CAN 2 HIGH CAN 2 LOW 32 22 CAN 2 HIGH CAN 2 LOW CN-51 CN-56A CN-5 300L6ES02 6-25 YES Check voltage YES between CN-56A (6, 7) and (3) NO Starting switch : ON Check voltage Voltage : 2V between CN-5 (5) and (6) Starting switch : ON Voltage :
2V NO Cause Remedy Defective cluster Disconnection in wiring harness or poor contact between CN-56A (6, 7)-CN-5 (5, 6) Defective MCU Disconnection in wiring harness or poor contact between CN-5 (5, 6)- CN-51(22, 32) Replace Repair or replace (after clean) Replace Repair or replace (after clean) YES 2V NO 0V 3 6 7 9 6 5