7. WHEN HYDRAULIC OIL TEMPERATURE WARNING LAMP LIGHTS UP (engine is started) · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted. · After checking, insert the disconnected connectors again immediately unless otherwise specified. Disconnect CN-51,52 Check Table CN-51 HYDRAULIC OIL TEMPERATURE SENDER 2 C GND(5V) 5 1 MCU CD-1 HYD OIL TEMP SENSOR 24 CN-52 900L6ES08 6-30 YES H Resistance YES between CD-1 (1, 2) is in range of 164~151Ω? Does display go Starting switch : ON D Disconnect CD-1 NO off when s disconnect CD-1? YES S Starting switch : ON Resistance b Engine :
Running between CN-51 s (5) and CN-52 NO (24) is 0~1Ω? D Starting switch : OFF NO Cause Remedy igh temperature efective temp ensor hort circuit etween temp ensor and MCU efective MCU Check hydraulic system Replace Repair or replace Replace Temperature (˚C ) ~ -30 ~ -10 ~ 0 ~ 40 ~ 70 ~ 80 ~ 90 ~ 100 105~ Resistance (kΩ) 22.22 ~31.78 8.16 ~10.74 5.18 ~ 6.6 1.06 ~1.28 0.39 ~0.476 0.322 ~0.298 0.243 ~0.219 0.185 ~0.167 0.164 0.151