Kaiyi — 3. ELECTRICAL SYSTEM

8. WHEN COOLANT TEMPERATURE GAUGE DOES NOT OPERATE · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted. · After checking, insert the disconnected connectors again immediately unless otherwise specified. Check Table CN-126 CN-51 connector 900L6ES02 6-31 YES Check resistance YES between engine harness connectors Spec : 180Ω~160 kΩ NO Check resistance between temp sensor (A)-(B) Starting switch : OFF Spec :

180Ω~160 kΩ See table NO Cause Remedy Check use HRDT Disconnection in wiring harness or poor contact between temp sensor-engine harness connector Defective coolant temp sensor Check or replace Repair or replace (after clean) Replace Temperature (˚C ) 0 25 50 80 95 Resistance (kΩ) 30~37 9.3~10.7 3.2~3.8 1.0~1.3 0.7~0.8 SERVICE TOOL CAN Lo F 6 CAN Hi E 5 RS232 TX C 3 RS232 RX B 2 P DUMP A 1 EMS INTERFACE 1 BATT. ECM 2 GROUND 31 3 IGN ECM 21 4 BATT. ECM ENGINE COOLANT TEMPERATURE SE 5 GROUND 24 6 CAN SIGNAL HI A 34 7 CAN SIGNAL LOW B C 8 ENG.RUNNING +24V 16 Engine harness CAN Lo F 31 21 24 34 16 CAN Hi E RS232 TX C RS232 RX B P DUMP A A B C