Kaiyi — 1. OPERATIONAL PERFORMANCE TEST

2) ENGINE SPEED (1) Measure the engine speed at each power mode The engine speed at each power mode must meet standard RPM; if not, all other operational performance data will be unreliable. It is essential to perform this test first. CLUSTER Preparation Warm up the machine, until the engine coolant temperature reaches 50 C or more, and the hydraulic oil is 50 ± 5 C. Set the accel dial at 10 (Max) position. Measure the engine RPM. (2) ① ② ③ (3) Measurement Start the engine. The engine will run at start idle speed. Measure engine speed with a engine rpm display. Measure and record the engine speed at each mode (P, S, E). Select the P-mode.

Lightly operate the bucket control lever a few times, then return the control lever to neutral; The engine will automatically enter the auto-idle speed after 4 seconds. Measure and record the auto deceleration speed. Engine RPM display Power mode switch Pilot lamp(P, S, E) ① ② ③ ④ ⑤ 480L7MS01 Evaluation The measured speeds should meet the following specifications. (4) Unit : rpm Condition : Set the accel dial at 10 (Max) position. 7-4 Model Engine speed Standard Remarks HX900 L Start idle 850±100 P mode 1750±50 S mode 1650±50 E mode 1550±50 Auto decel 1000±100 One touch decel 850±100