Unit : mm / 20 m 7-7 5) TRAVEL DEVIATION (1) Measure the deviation by the tracks from a 20 m straight line. (2) Preparation ① Adjust the tension of both tracks to be equal. ② Provide a flat, solid test yard 20 m in length, with extra length of 3 to 5 m on both ends for machine acceleration and deceleration. ③ Hold the bucket 0.3 to 0.5 m above the ground with the arm and bucket rolled in. ④ Keep the hydraulic oil temperature at 50±5˚C. (3) Measurement ① Measure the amount of mistracking at high and low travel speeds. ② Before beginning each test, select the following switch positions. · Power mode switch :
P mode ③ Start traveling the machine in the acceleration zone with the travel levers at full stroke. ④ Measure the distance between a straight 20 m line and the track made by the machine. (Dimension a) ⑤ After measuring the tracking in forward travel, turn the upperstructure 180˚ and measure that in reverse travel. ⑥ Repeat steps ④ and ⑤ three times and calculate the average values. (4) Evaluation 0.3~0.5m 480A7MS02 3~5 m extra length a 20M 3~5 m extra length (210-7) 7-7(2) 0.3~0.5m 480A7MS02 Mistrack should be within the following spe cifications. Model Standard Maximum allowable Remarks HX900 L 200 below 250 -