Unit : kgf / cm 2 7-18 1 5) SWING PARKING BRAKE RELEASING PRES SURE (1)Preparation ① Stop the engine. ② Loosen the cap and relieve the pressure SH in the tank by pushing the top of the air breather. ③ The pressure release L wrench to bleed air. ④ Install a connector and pressure gauge assembly to swing motor SH port, as shown. ⑤ Start the engine and check for oil leakage from the adapter. ⑥ Keep the hydraulic oil temperature at 50±5˚C. (2) Measurement 900L7MS10 ① Select the following switch positions. ·Power mode switch : P mode ② Operate the swing function or arm roll in function and measure the swing brake control pressure with the brake disengaged.
Release the control lever to return to neutral and measure the control pressure when the brake is applied. Repeat step ② three times and calculate the average values. (3) Evaluation SH 900L7MS10 The average measured pressure should be within the following specifications. Model Description Standard Allo wable limits Remarks X900 L Brake disengaged 40 31~42 Brake applied 0 -