Kaiyi — 5. SWING DEVICE

(5) Remove No.1 carrier assembly. 900L8SM72 (6) Disassembling of No.1 carrier assembly During periodical inspection or so on, it is unnecessary to disassemble No.1 carrier assembly more. In this state, check parts according to inspection shown in section 6. As mentioned above, it is recommended to replace No.1 carrier assembly as set as far as possible. However, if partial replacement is inevitable, follow procedures mentioned below. ① Press spring pin (909) in the more inner part and pull out pin No.1 (283). If pin No.1 (283) is removed do not use in reassembly of reduction gear. Remove No.1 planetary gear (210), needle cage (403), side plate (285). ② (7) Lift up ring gear (202) to remove.

900L8SM73 8-66