Kaiyi — 5. SWING DEVICE

(8) Remove No. 2 sun gear (204). (9) Remove No.3 carrier assembly. (10) Disassembling of carrier No.2 During periodical inspection or so on, it is unnecessary to disassemble No.2 carrier assembly more. In this state, check parts according to inspection shown in section 6. As mentioned above, it is recommended to replace No.2 carrier assembly as set as far as possible. However, if partial replacement is inevitable, follow procedures mentioned below. ① Press spring pin (910) in the more inner part and pull out pin No.2 (282). If pin No.2 (282) is removed do not use in reassembly of reduction gear. ② Pull out to remove planetary gear No.2 (203) and thrust washer (286).

(11) Remove snap ring (913) from driving shaft (201). 900L8SM74 (12) Place the reduction gear in a vertical with end of drive shaft, face down. During periodical inspection or so on, it is unnecessary to disassemble drive shaft assembly more. In this state, check parts according to inspection shown in section 6. As mentioned above, it is recommended to replace drive shaft assembly as set as far as possible. However, if partial replacement is inevitable, follow procedures mentioned below. 8-67