ENGINE MAINTENANCE - Maintenance Procedures Fuel Filter Removal 4. Fuel Filter Housing cleaned and reused. Dispose of the filter as chemical waste. Procedure for removing the engine fuel filter. 1. Clean the fuel filter cap and surrounding area to ensure dirt does not fall into the fuel module. Follow the steps below to remove the fuel filter: 4. Remove the fuel filter cartridge. 2 CAUTION Fuel Filter Installation Fuel Module Dirt in the fuel system can lead to significant damage to the fuel system. Failure to comply may result in equipment or property damage. Procedure for installing the PACCAR PX-7 or PX-9 fuel filter. 1 Follow the steps below to install a new fuel filter: 1.
Verify the sealing O-ring that is supplied with the filter kit is installed on the fuel filter cap and lightly coat the O-ring with fuel. 2. Install the new fuel filter cartridge to the cap, then insert into the fuel module. 2 2. Loosen the fuel tank cap to relieve any pressure in the fuel tank. 3. Remove the fuel filter cap by rotating it counter-clockwise with a wrench, automatic draining of fuel will be initiated, wait 5 minutes for complete fuel draining to prevent fuel from leaking or dripping on the starter motor. 3 NOTE Depending on the vehicle’s fuel system configuration the fuel fil- ter housing may not completely drain of fuel.
If this is the case, take care when installing the new filter as this may cause fuel to spill from the filter housing. 4 NOTE The fuel filter cartridge is a dis- posable filter and must not be 1. Fuel Filter Cap 2. Fuel Filter 3. Manual Priming Pump Y53-1183-1E1 (04/16/18) 63