PACCAR PX-7 — Starting After the Fuel Tank Has Run Dry or After Fuel System Service has been Performed

ENGINE MAINTENANCE - Maintenance Procedures CAUTION WARNING NOTE The following instructions should only be used in emergency situations when the fuel tank has run dry. Failure to fol- low the starting instructions below may damage the starter motor. Check the fuel filter for signs of leakage. DO NOT smoke or al- low an open flame in close prox- imity. Failure to do so could ignite a fire or cause an explosion which could result in serious in- jury to you and/or bystanders. Failure to comply may result in death, personal injury, equipment or property damage.

Allowing the engine to idle for several minutes with the fuel blending valve in the prime posti- tion assists in purging air from the fuel system. 2 6. Check the system for leakage while idling. Then turn the engine off and check the system again for leakage. 7. If the engine does not start within this time, repeat steps two and three until the engine starts. If the engine still does not start, allow the starter to cool down for at least 5 minutes before repeating the procedure. 1. Loosen the fuel primer pump knob by rotating it counter-clockwise. 2. If equipped with a return fuel blending valve, turn the valve to the PRIME (closed) position. 3.

Operate the priming pump by moving the knob in and out for 150 seconds. During this time the pumping resistance will increase, but the full time is required to fully prime the fuel system. 5. Start the engine and allow it to idle for several minutes. Note that it could take up to 15 seconds of cranking for the engine to start. If the starter is engaged for longer than 20 seconds without starting, additional priming pump actuation may be necessary. Fuel Blending Valve 1 2 CAUTION CAUTION Operate priming pump at a maxi- mum rate of 30 strokes per mi- nute to prevent damage to pump.

If the engine is cranked exces- sively Starter Protection will be triggered and starter engage- ment will be restricted for 10 mi- nutes. 4. Check for leakage at the fuel filtercap. Tighten if necessary. Y53-1183-1E1 (04/16/18) 65