. OPERATION MACHINE OPERATIONS AND CONTROLS REMARK softer. 3 - 92 Adjusting seat heig It is possible to move t he seat up or down by combining a djustments f orward tilt a nd rear tilt. After setting the forwar d tilt or rear tilt to the desire d height , operate the opposite p art to set th e seat horizontal t hen secure in position. Height adjustment: 60 (D) Adjusting armrest Armrest (5) can be ma de to spring up by hand ap prox. 90 In addition, by turning the bottom (6) of the armre st by ha nd it i s possi ble to make fine vertic al adjustments of the armrest angle.
Armrest adjustment an If the seat back is ti pped to the front without ra ising th e armrest(5), armrest wil l rise automatically If the cable at the r ear of armrest (5) is tense ( when th e seat back i s tipped to the front), a rmrest (5) canno t be dial (6). When adjusting th e angle of armrest (5 ), set the s eat back to a position where it is perations, then adjust the a (E) Overall fore-and-af t adjustment of seat Move lever (7) to right, set to the desired position , then re lease the lev er. In this c ase, the op erator's seat, left and right control levers, an d lock lever all slide togeth er.
s) Fore-and-aft adjustme nt:180 mm (7.1 in) (9 stage (F) Adjusting suspensi on ght to make the suspension harder,or to the left to make the suspens Turn knob (8) to the ri reading of the dial to m atch the operator's weight and sel ect the optim um suspen sion. Adjust the REMARK To obtain the optimum adjustment, turn the knob ( 8) so tha t the i ndicator of the weig ht display ( kg) in the t ransparent portion of knob (8) is t he same as the operator's weight.