Komatsu — PROCEDURE FOR INCREASING OR REDUCING TRACK FRAME GAUGE

. OPERATION TRANSPORTATION be extended. structure so that it is at 90 ° on the opposite 3 - 146 Increasing Track Gau 1. Remove center fr ame mounting bolt s (2) (o ne side, f ront + re ar: 8 bolts) from the f ront and rear of the track frame on the sid e to 2. side to track fram REMARK Height H of the track f rame being raised should be less t han 50 mm (2 in). Take care no t to raise the track frame so much that the ed. the stopper bolt is distort 3. Using the arm, p ull the machine to t he fro The track frame 4. Extend the track the stopper, then low er the machine sl owly to the gro und. Install bolts (1) (one s ide, front + rear: 16 bolts) and tighten to e:

1960 - 2450 Nm (200 - 250 kgm , 1450 - 1810 lbft) procedure to retract the track frame on the hine on firm level ground when extending or rack frame gauge width. the cylinders suddenly when extending or track frame gauge width. It is dangerous if ted suddenly. specified torque. 5. Tightening torqu e: 1960 - 2450 Nm 6. Follow the same other side. Stop the mac retracting the t Never operate retracting the they are opera 1450 - 1810 lb ground rack frame gauge width. Never operate the cylinders suddenly track frame gauge