Komatsu — RUNNING OUT OF FUEL

. OPERATION TROUBLES AND ACTIONS TROUBLES AND ACTIONS Procedure for Bleeding Air CAUTION 1. Loosen plug (A) at the top of fuel main filter head (1). NOTICE Do not loosen the plug of the fuel pre-filter head. This is at the suction end, so if it is loosened, it will be impossible to bleed the air. the 3 - 153 RUNNING OUT OF F When starting the engine again after running out of fuel, fill wit h fue l, then bleed the air from the fuel system before startin g the engine.

Alway s watch the fuel le vel and be careful not to run out of fu If t he e ngine has stopped because of lack of fuel, it is necessar y to u se the priming pump to b leed the air completely from t This engine consists of h igher precision parts than on the conventional f uel injection pump and noz zle, so if dirt gets in, it will cau se problems. If there is any dirt stuck to the fuel line, use fuel to was h it off completely. Be c areful when opening the air bleed plug for the f uel filter head. If ther e is any remaining pressur e, the fuel may spurt out.

Whe n bleeding the air im mediately after the engine has run out o f fuel, the area around the engin e is extremely hot, so be care ful not to burn yours elf . Lo osen butterfly nut (2) holding the lever of t he priming pu . O perate the lever of the priming pump to pri me with uel. wi W pri ll come out from plu g (A) at the top of the fue l main filter h hen no more bub bles come out wih the fuel, operate ming pump lever more slowly. Tighten plu