Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. Komatsu Supercoolant (AF-NAC) is strongly recommended wherever available. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%.

Supercoolant (AF-NAC) is already diluted with distilled water. When using coolant, investigate the lowest temperatures in the past and decide the density for the coolant from the coolant density table below. When actually deciding the density for the coolant, set it for a temperature 10 ° C (18 ° F) lbelow the actual temperature. The coolant density varies according to the ambient temperature, but it must always be a minimum of 30%. Coolant density table 4 - 24 Immediately after th e engine i s stopped, t he coolant is at a high temperatu re and th e radiator is under high interna l pressure. If the cap is r emove d to drain t he coolant in this conditio n, there is a hazard of burns.

Wait for the temperatur e to go down, then turn t he cap slowly to release the pressur e before remo ving it. When starti the machine, movin For de tails o f startin g the engi ne, see "BEFORE STARTI NG ENGINE (PAGE 3-79)" an d "STARTING ENGINE ( PAGE 3 -98)" i n the OPERATION sectio n. ouching the fan if the undercover is left removed. the machine when the engine is running.

There is danger of t ouching th e fan if the undercover is left removed Never enter behind the machi ne when the engine is run ck position to prevent the machine from Stop th e machine o n level gr ound when cleaning or changing the Clean t he inside of t he coolin g system, change the coolant according to the table below. Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first Minimum Temp °C Above -10 -15 -20 -25 -30 -35 -40 -45 -50 °F Above 14 5 -4 -13 -22 -31 -40 -49 -58 Concentration (%) 30 36 41 46 50 54 58 61 64