Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE WARNING 4 - 25 Antifreeze is toxic. When open t he drain valve, be careful not to get water containing antifreeze on y ou. If it gets in your eyes, flush your eyes with large amou nt of fresh water and see a doctor at once. When changing the coolant or d raining the coolant from the radiator before carrying out repairs, as k a specialist company to handle any coolant containing antifreeze, or contact your Komatsu distributor. Antifreeze is toxic, so never pour it into t onto the ground surface. drainage water ditches or drain i The coolant is already diluted w ith distilled water.

(For details of the distilled water, see "CO OLANT AND WATER FOR DILUTION (PAGE 4-5)". Check the density with a coolant tester. Prepare a container whose cap acity is larger than the specified coolant volume to catch dr Prepare a hose to use when fill 1. Stop the machine on level ground, then stop the engine. ator water filler slowly. 2. Turn cap (1), (2) of the radi 3. Remove covers (3), (4), and (5), then place containers to catch the drained coolant under w the radiator, and under engi of the engine oil pan. ater drain valves (6) and (7) under ne coolant drain valve (8) at the top nd (8) drain the water. 4. Open drain valves (6), (7) a 5.

After draining the antifreeze solution, close drain valves (6), (7) and (8), then fill with clean w water, start and run the en water temperature rises ab for about 10 minutes. ater. After the radiator is filled with gine at low idling speed. After the ove 90°C (194°F), run the engine 6. Stop the engine and open d rain valves (6), (7), and (8) to drain the water. an the radiator with detergent. flushing operation, follow the lushing agent. and (8). and (5). the water filler up to the bottom of olant density, see the COOLANT g for 5 minutes to remove the air high idling for 5 minutes. (Leave hen doing this.) 7.

After draining the water, cle When carrying out the instructions given with the f 8. Close drain valves (6), (7), 9. Install undercovers (3), (4), 10. Add Supercoolant through the filler port. For details of the Superco DENSITY TABLE. 11. Run the engine at low idlin from the water, then run at radiator cap (1) removed w 12. After draining off the coolan t of sub tank (9), clean the inside of the sub tank and refill the wa If the sub-tank is extrem replace it with a new part ter between FULL and LOW level. ely dirty and it is difficult to clean, . 13. Stop the engine, wait for ap prox. 3 minutes, add Supercoolant up to the bottom of the filler (1). port, then tighten the radiator cap