Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE out from air bleed lever and set to 5) Install the travel motor cover. for at least 5 minutes before starting 4 - 41 6. Bleeding air from travel motor f t he piping has been remove rcuit, bleed engine the ai at lo r after w idling reassembli and do as ng. To bleed the air, run the follows. low idling. 1) Start the engine and run at 2) Remove travel motor cover (1), then lo osen a ir bleed plug (2) one t NOTIC Do not loosen plu g (2) mor e than one t 3) plug (2), tighten air bleed p 4) Carry o ut fine operation of the trav FORWA RD and REVERS E 4 - 5 time 7. 1) After co mpleting ngine operatio ns.

This will allow t he bubbles in the o il insid e the tank to 2) Check th at there is no leak age of oil, a nd wip e up an y oil t hat has