Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE NOTICE 4 - 40 3. Bleeding air from cylinder idle, and extend and retract each c ylinder 4 to 5 times, tak ing care that a cylinder is of its stroke. (Stop the cylinder app rox. 100 mm (3.9 in) sh linder 3 to 4 times to the end of its stroke. cylinder 4 to 5 times to the end of it s stroke to completely r If the engine is run at high speed i mmediately after startup or a cylinder is pushed up to its stroke end , air taken inside the cylinder may cause damage to the piston 4.

Bleeding air from swing motor (bleed the air only when the oi When oil has been drained from inside swing motor case 1) Run the engine at low idling, loosen hose (1) at port S, and check that oil oozes out from port S hose (1). NOTICE Do not operate the swing under any circumstances. 2) If oil does not ooze out, stop the engine, remove port S hose (1), and fill the inside of the motor case with hydraulic oil. 4. Bleeding air from swing m otor (bleed the air only when the oi l inside the swing motor case has been drained) ned from inside swing motor case idling, loosen hose (1) at port S, and Do not operate the swing under a ing air from swing motor, tighten p ort S hose (1).

dle, and slowly swing the upper stru cture at least 2 times uni formly to the left and right. NOTICE wing motor, the motor bearings may be damaged. If the air is not bled from the s wing motor, the motor bearings may be Use the above procedure also to bleed the air when the swing motor s afety valve has been repla 5. Bleeding air from attachm ent (when installed) If an attachment has been (approx. 10 times) until th installed, run the engine at low idli ng and operate the atta chment pedal repeatedly e air has been bled from the attach ment and circuit.

NOTICE If the method of bleeding the air from the attachment itself is specifie d by the manufacturer, bl eed the air according to the specified procedure. After completing the air bleedi ng operation, stop the engine, and leave the machine for 5 minute s before starting operations. This will remove the air bubble s in the oil inside the hydraulic cylinder s. spilled. Check that there is no leakage of oil and wipe off any oil that has been