Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE CAUTION 2. Starting engine Cancel the automatic warming-up operation before starting the engine. Run the engine at low idling for 10 minutes after starting it, then go on to the next operation. 4 - 39 BLEEDING AIR FROM HYDRAULIC SYSTEM For details of the procedure when starting the engine, see "STARTING ENGINE (PAGE 3-98)". If necessary, refer to the OPERA TION volume for the sections for starting the engine, moving the m achine off, steering, and stopping. When starting t he engine to bleed the air, cancel the automatic warming-up operation be NOTICE r as follows.

rk equipment, swing) ipment circuit ine at less than 1000 rpm, and operate the cylinders slowly. enly stop and cause the cylinder pressure to rise or operate to the end of the stroke. ting the cylinder for the first stroke (extending and retracting), operate particularly slowly. Bleed the ai 1. Pump (wo 2. Work equ Run the eng Do not sudd enly stop and cause the cylinder pressure to rise or operate to the end of When opera ting the cylinder for the first stroke (extending and retracting), operate par When opera ting the cylinder for the first stroke, there is a large amount of air inside the circuit, so the work equipment will not move for at least 10 seconds.

Be careful not to operate the lever to the end of the stro ke. l can. Use clean oi l of NAS7 class or above when filling the pump. Be sure to use a clean oi Carry out Ste ps 1 - 3 below to bleed the air. If necessary, carry out Steps 4 - 6 in addition. 1. Bleeding air from pump 1) Loosen air bleed plug (1) and check that oil oozes out from air bleeder (2). 2) If oil does not ooze out, remove the drain hose and elbow from the pump case, and fill the pump case with hydraulic oil through drain port (3). If the mouthpiece is lower than the oil level in the hydraulic tank, oil will come out from the drain hose when it is removed.

To prevent this, fix the mouthpiece of the hose at a position higher than the oil level in the hydraulic tank. 3) After completing the air bleed operation, tighten air bleeder (1) and install the drain hose. . Bleeding NOTICE If t he drain hos e is installed first, oil will spurt out from plug (1) hole. If the pump is oper ated without filling the pump case with hydraulic oil, a bnormal heat will be generated and this may cause premature damage to t he pump.