. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE available (sodium or or there is no display of the UPPER REMARK with of your 4 - 48 2. UPPER LEVEL (U. L.) and LOWER LEVE L (L.L.) lines, r cap (2) and add p urified water (e.g. co replenishment wate r for a battery) to the 3. After adding distille d water, tighten cap (2 REMARK d to above the UPPER LEVEL (U.L If distilled water is adde d to above the UPPE use a syringe to lower the level to the UPPE R LEVEL (U.L Neutralize the remo ved fluid with bak h it away with a large ing soda (s amount of w aker.
bicarbonate), then flus consult your Komatsu distributor or battery m When it is Impossible to Check Electrolyte Level from Side of Battery If it is impossible to ch eck the electrolyte lev el from the si as follows. batter LEVEL line on the side of the battery, check 1. Remove cap (2) at t he top of the battery, lo ok through th filler port (3), and electrolyte does no check the electrol t reach the sleeve (4 yte surface. ), add purified (e.g. commercially available replenishme nt water for a b so that the level re LEVEL line) withou (A) Suitable leve l: Electrolyte level is up to bottom of so surface tension surface to bulge and causes elec poles appea (B) Low:
Electrol yte level is not up to ppear straight and not 2. After adding distille d water, tighten cap (2 to remove electrolyte. sodium bicarbonate, th Neutralize the remo en flush it away with ved electrolyt a large amo water. If necessary, c battery maker. When it is Possible to Use Indicator to Check Electrolyte Le If it is possible to use a n indicator to check th e electrolyte l evel, follow the instructio