Komatsu — EVERY 250 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Checking conditioner compressor pulley (4). (A): 10 mm (0.4 in) Adjustment 3. Install cover (1). 4 - 51 1. Remove 4 bolts (2) , then remove cover ( The standard defle with a thumb [at a ction for the drive belt is of (A) pprox.98.1 N (approximately when pressed 10kgf)] at a point midway bet 1. Loosen bolts and n uts (5) - (7) in number order, and mov e the compressor to the If nut (8) is tighte ned, the belt tension w ill increase. If nu t (8) is loosened, the belt tension will be rel ieved. 2. After adjusting the reverse order to th Check each pull wear of the V-be lt.

Check in particular not contact the b ottom of the V-groove If the V-belt is el ongated and there is n o more allowanc e for adjustment, or if the belt is cracked or cut, replace the belt. When the V-be after running for 1 ho -groove, and does