Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE FUEL PRE-FILTER CARTRIDGE WARNING 2. Set a container under fuel pre-filter cartridge (2) to catch the drained fuel. 3. Turn transparent cap (3) of the water separator installed to the bottom of the cartridge to the left to remove it. ( The transparent cap is used again. ) 4. Using a filter wrench, turn filter cartridge (2) counterclockwise to remove it. 5. Install transparentcap (3) to the bottom of the new fuel pre-filter cartridge. ( When doing this, always replace the seal with a new part. ) Tightening torque for transparent cap:

10.0 Nm ( 1.0 kgm , 7.2 lbft) 4 - 52 EVERY 500 HOURS MAINT ENANCE Maintenance for every 10, 100, a nd 250 hours of service should be performed at the same After the engine has been operated , all parts are at high temperature, so do not replace the filter imm ediately. Wait for all parts to cool down before starting the o peration. the engine fuel piping system when the engine is running. High pressure is generated inside When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before replacing the filter. e. eed plug in the fuel filter head. It is still under pressure, so fuel may spurt out.

Do not bring any fire or flame clos Be careful when opening the air bl eed plug in the fuel filter head. It is still under pressure, so fuel NOTICE Genuine Komatsu fuel filter cartri dges use a special filter that has highly efficient filtering ability. When replacing the filter cartridge, always use a genuine K omatsu part. The common rail fuel injection sys tem used on this machine consists of more precise parts than t he conventional injection pump and nozzle. If any part other than a genuine Ko matsu filter cartridge is used, dust or dirt may get in and cause p roblems with the injection system. Always avoid using subs titute parts.

When carrying out inspection or m aintenance of the fuel system, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. Container to catch the oil Prepare a filter wrench 1. Turn valve (1) at the bottom o it. 1. Turn valve (1) at the bottom o