. MAINTENANCE MAINTENANCE PROCEDURE coat the packing surface of the new filter cartridge thinly with oil, then install the filter NOTICE portion on the clean side. Bleed the air as follows: 10. Loosen plug (A) at the top of fuel main filter cartridge (4). NOTICE Do not loosen the plug of the fuel pre-filter head. This is at the suction end, so if it is loosened, it will be impossible to bleed the air. 4 - 53 6. cartridge to the filter ho When adding fuel, do not r emove cap (B). Always add fuel f small holes (A) on the dirty After adding fuel, remove c Always fill with clean fuel. Be careful not to let any dirt or du the fuel.
In particular, cente r portion is the clean side, so do n cap (B) when adding fuel. B e careful not to let dirt or dust get i 7. When installing, tighten until the packing surface cont acts the s eal surface of the filter h older, then tighten it 3/4 of a turn. If the filter cartridge is t ightened too far, the packing w ill be damaged and this will lead t o leakage of fuel. If the filter cartridge is too lo ose, fuel will also leak from the packing, so always tighten the c When tightening wit h a filter wrench, be extremely careful no t to dent or damage the 8. Check that drain plug ( 5) at the bottom of transparen t cap (3) is Tightening torque: 0.2 to 0.45 Nm (0.02 to 0.046 kgm 9.
After completing the re placement of fuel pre-filter car tridge (2),