. MAINTENANCE MAINTENANCE PROCEDURE CLEAN,CHECK RADIATOR FINS,OIL COOLER FINS,FUEL COOLER FINS,AFTERCOOLER FINS,CONDENSER FINS (machines equipped with air conditioner),PTO OIL COOLER WARNING 1. Open the engine hood and rear duct (1) on the right side of the machine. 2. Loosen screw (2) and pull up net (3). 3. Clean net (3). (it is to be installed again, as instructed in the step 8.) 4. Loosen bolts (5) of top cover (4) on the engine side, then slide cover (4) to the rear. 5. Check the front face and rear face of oil cooler fins (6), radiator fins (7), aftercooler fins (8), condenser fins (9), and fuel cooler fins (10). If there are any leaves, mud, or dirt, blow off with compressed air.
Steam or water can be used instead of compressed air, or the fan can be rotated in reverse to carry out cleaning. For details of the method for rotating the fan in reverse, see "MONITORING SYSTEM (PAGE 3-5)" 6. Check the rubber hose. Replace with a new one if the hose is found to have cracks or to be hardened by aging. In addition, check the hose clamps for looseness. 4 - 56 If co mpressed air, high-pressure water, or steam hits your body directly or dirt i s sent flying by the co mpressed air, high-pressure wat er, or steam, there is danger of pers onal injury. Always wear protective glasses, dust mask, and other protective equipment. NOTICE a distance to prevent damage to the fins.
Whe n using compressed air, use from a distance to prevent damage to the fin In p articular, with the fuel cooler and af tercooler, blow with compressed air at an angle of 45° with t he nozzle at a distance of at leas t 300 mm (11.8 in). Nev er blow the compressed air at right angles to the core. If the fins are damaged, it may cause coo lant leakage or overheating. On dusty jobsites, check the fins daily, irrespective of the maintenance interva l. REMARK Ins ert the pin of the bar supporting the hood fully open.