Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING and may cause burns. Wait for the for more than 5 minutes to 4 - 65 temperature to go down before starting When remov ing the oil filler cap, turn it slowly to release the inte rnal pressure, then 1. Set the w ork equipment on the hard and flat ground in the maintenan ceposture as shown in the figure, then lower it to the ground an d stop the engine. 2. Remove t he cap from oil filler (F) on top of the hydraulic tank, and releas e the internal pressure . er (1). 3. Loosen 4 bolts, then remove cov When doin g this, the cover may fly out under the force of spring (2), hold t he cover down when re 4.

After rem element ( If there (5), con element ( If there are metal particles or fo reign material inside st rainer tact your Komatsu distr ibutor. ng oil. 5. Clean the removed parts in flushi 6. Install the new element in the plac e where old element (4 ) was installed. 7. Set valve (3), strainer (5) and spri ng (2) on top of the ele ment. 8. Set cover (1) in position, push it d own by hand, and inst all the cover with the mounting bolts. according to "Engine Warm 9. Install the cap of oil filler port (F). 10. To bleed t he air, start the engine Warm Up (PAG E 3-102)" and run the engine at low idle for 10 ngine. minutes. 11.

Stop the e REMARK Operate the machine after halting f eliminate bub bles in the oil inside the 12. Check for oil leakage and wipe of