Komatsu — EVERY 2000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT WARNING 4 - 78 Th e hydraulic syst em is always under inter nal pressure, so when inspecting or replacing the pipi ng or hoses, always release the pressure in the personal injury. pressure in the circuit before starting. If the pressure i s not releas ed, high pressure oil may s purt out and cause serious Th e parts and oil ar e at high temperature a fter the engine i s stopped, a nd may cause serious burn s. Wait for the temperature to go down before starting the operation. When the oil filler c ap is removed, oil may spurt out, so tur n the cap sl owly to release the pressur e before removing the cap. 1.

S top the machi ne on firm horizonta l ground, lowe r the work e th quipment to th e ground as shown in the diagram o n the right, en stop the e ngine. ever at the FREE position (F). ork equipment control lever to the full stroke onds after stopping the engine. arting switch at the ON position. Set the lock l ever at the FREE po 2. O perate each w ork equipment contr w ithin 5 - 6 sec onds after stopping th Leave the st arting switch at the O 3. R emove the ca p of the hydraulic tan k. econds, then stop the engine again. n 1000 rpm. vers to the HOLD position. 4. S tart the engine , run for approx. 10 s econds, then stop the en Do not run th e engine at more tha n 1000 rpm.

Set the work equipment control le vers to the HO LD positio 5. O perate each w ork equipment contr ol lever to the f ull stroke within 5 - 6 seconds afte Repeat Step s 4 - 5 three times. CHECK ALTERN Contact your Koma tsu distributor to hav e the alternato r checked. If the engine is star ted frequently, have t his inspection carried out