Komatsu — EVERY 5000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN HYDRAULIC TANK WARNING the engine is stopped, and may cause burns. Wait for the plugs 4 - 82 EVERY 5000 HOURS M Maintenance for every 10, 1 00, 250, 500, 1000, and 200 0 hours of service should be perfor med at the same time The parts and oil are at hig temperature to go down befo When removing the oil filler cap, turn it slowly to release the Refill capacity: 360 liters ( Prepare a handle for sock 1. 1. Swing the upper structu (P1), (P2) under the tan k and the bottom of the pum tube are in the middle b etween the left and right track 2. Retract the arm and buc ket cylinders, then lower the b put the teeth in contact 3.

Set the lock lever to the LOCK position and stop the 4. Remove the undercover 5. Remove the cap of oil fil tank. 6. Set a container under th e drain plug to catch the drai Remove (P1) of drain pl ug (P), then loosen (P2) and oil. After draining the oil, tighten drain plugs (P1) and Tightening torque: 68 .6 ± 9.8 Nm (7 ± 1 kgm , 50 When loosening drain p yourself. lug (P2) be careful not to get oil on 7. Add the replacement am ount of oil through oil filler (F ). Check that the oil level is betwee n the H and L lines on the sight gauge. eck, see "Check Oil Level in Hydraulic Tank, Add Oil (PAGE 3-86)". For details of oil level ch eck, see "Check Oil Level in Hydraulic 8.

Bleed the air from the ci rcuit after cleaning or replaci ng the filte r element or strainer, or a fter changing the oil. 9. Install the undercover un der drain plug (P).