Komatsu — EVERY 10 HOURS MAINTENANCE

. LOADING SHOVEL MAINTENANCE EVERY 10 HOURS MAINTENANCE 7 - 18 LUBRICATTIN 1. Set the wo rk equipment in the greasing posture below, t hen lower the wor k equipment to the ground and stop the engine 2. Using a gr ease pump, pump in grease through t he grease fittings shown 3.

After greasing, wipe off any o ld grease that was pushed out (1) Boom cylinder foot pin (2 (2) Arm - Bucket coupling pin (3) Bucket hinge pin (2 place (4) Bottom dump cylinder rod end pin (2 places) (5) Bottom dump cylinder foo t pin (2 places (6) Bucket cylinder foot pin (7) Boom centralized lubricati ng block (9 places Boom f oot pin linder foot pin Arm cy Boom cylinder rod end pin Bucket cylinder rod end pi Boom - Arm coupling pin ( (8) Arm cy linder rod end pin ( (9) Boom - Arm coupling pin ( Arm side) (2 places)