. LOADING SHOVEL MAINTENANCE CHANGE OIL IN HYDRAULIC TANK, CLEAN STRAINER WARNING engine is stopped, and may cause burns. Wait for the the 7 - 19 EVERY 5000 HOURS MA Maintenance for every 10 hou rs service should be carried out The parts and oil are at high temperature to go down before When removing the oil filler ca p, turn it slowly to release the intern Refill capacity: 360 liters (9 5.1 US gal) t wrench set e so that the drain plug under een both tracks. Prepare a handle for socke 1. 2. 3. 1. Swing the upper structur hydraulic tank will be betw 2.
Retract the arm cylinder, e xtend the bucket cylinder, lower boom, set the bottom of th e bucket in contact with the gro then stop the engine. 3. Set the lock lever to the L OCK position and stop the engi 4. Remove the undercover u 5. Remove the cap of oil fille r port (F) at the top of the hydra tank. 6. Set a container under the drain plug to catch the drained Remove (P1) of drain plug (P), then loosen (P2) and drain oil. After draining the oil, ti ghten drain plugs (P1) and (P2) Tightening torque: 68.6 ± 9.8 Nm (7 ± 1 kgm , 50 ± 7 lb When loosening drain plu yourself. g (P2) be careful not to get oil on 7. Add the replacement amo unt of oil through oil filler (F).
Ch eck that the oil level is betwee n the H and L lines on the sight gauge. ck, see "Check Oil Level in Hydraulic Tank, Add Oil (PAGE 3-86)". For details of oil level che ck, see "Check Oil Level in Hyd 8. Bleed the air from the circ uit after cleaning or replacing th e filter element or strainer, or after changing the oil. 9. Install the undercover und er drain plug (P).